Also the fender flares were a major PIA. the reason is that i wanted to make them functional which required cutting and re-welding the rear fenders. i should have done this on the rotisserie but hindsight is 20/20
Sunday, March 10, 2013
Differential Crossmember and Fender Flares
I finished installing the zg fender flares and modified the cross member for the sti differential that i am running. the mount for the differential is a little stiff (might be noisy at speed) but it ensures that my driveline is parallel to the car. this is important because i am running a single piece driveshaft with two rubber couplers; so it cannot tolerate much misalignment.
Also the fender flares were a major PIA. the reason is that i wanted to make them functional which required cutting and re-welding the rear fenders. i should have done this on the rotisserie but hindsight is 20/20
Also the fender flares were a major PIA. the reason is that i wanted to make them functional which required cutting and re-welding the rear fenders. i should have done this on the rotisserie but hindsight is 20/20
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment